G21LD · G21HD, WSM
Dismounting Grass Collector [G21HD]
1. Refer to "HIGH DUMP GRASS COLLECTOR" section.
Discharging Plate and Discharge Duct
1. Remove the discharging plate (1).
2. Remove the discharge duct (3) from the platform (5).
(1) Discharging Plate
(2) M6 Bolt
(3) Discharge Duct
Seat
1. Disconnect the 2P connector (3) from the seat switch.
2. Remove the seat support mounting lock nuts (1).
3. Remove the guide washers, spring washers and screws (4).
4. Remove the seat with seat support (5).
5. Remove the seat bracket (2).
(When reassembling)
• Turn the seat support mounting lock nuts all the way until it seats
lightly.
Then, turn seat support mounting lock nuts counterclockwise
by a half turn.
• Apply oil to the seat support.
• Face smooth side the plain washers (6) to the seat support.
(1) Seat Support Mounting Lock Nuts
(2) Seat Bracket
(3) 2P Connector
(4) Screws
Cutting Height Adjusting Dial
1. Lift the mower to the highest position.
2. Remove the cam mounting nut (1).
3. Remove the cutting height adjusting dial, plain washer and cam
(2).
(When reassembling)
• Apply grease to the outside of cam.
Tightening torque
Cam mounting nut
(1) Cam Mounting Nut
3-S7
BRAKES
W1016642
(4) M8 Bolt
(5) Platform
W1017021
(5) Seat Support
(6) Plain Washers
(7) Fender
39.2 to 45.1 N·m
4.0 to 4.6 kgf·m
28.9 to 33.3 ft-lbs
(2) Cam
KiSC issued 08, 2007 A