Kubota G21LD / G21HD Workshop Manual page 244

G21LD · G21HD, WSM
Separating Fender
1. Remove the speed change pedal.
2. Peel the step sheet (1) halfway.
3. Remove the step support mounting screws (2).
4. Remove the step support (5) and rubber bushing (6).
5. Remove the fuel cap (4).
6. Separate the fender from the frame.
(When reassembling)
• Apply grease to the inside of rubber bushing.
• Clean up the step sheet and the step. Apply instantaneous
adhesive on the step sheet as shown in the figure.
• Position the step sheet so that the clearance between the step
sheet and the panel is less than 2.0 mm (0.079 in.) as shown in
the figure.
(1) Step Sheet
(2) Step Support Mounting Screws
(3) Fuel Cap
(4) Step Support
(5) Rubber Bushing
Connector, PTO Clutch Return Cable and Cylinder Hose
1. Disconnect the 2P connector (3) from the grass collector switch.
2. Remove the wiring (2) from the platform.
3. Disconnect the PTO clutch return cable (4).
4. Remove the PTO clutch return cable (4) from the platform.
5. Remove the grass collector cylinder hoses (1) from the grass
collector cylinder.
(When reassembling)
• After assembling the PTO clutch return cable, be sure to adjust
the PTO clutch return cable (See page 7-S6).
• Attach the center hydraulic hose of the control valve to the upper
adapter of the grass collector cylinder.
• Attach the outer hydraulic hose of the control valve to the lower
adaptor of the grass collector cylinder.
Grass collector cylinder
Tightening torque
hose
(1) Grass Collector Cylinder Hoses
(2) Wiring
6-S10
HYDRAULIC SYSTEM
A : Less than 2.0mm (0.079 in.)
B : Panel
W1016411
21.6 N·m
2.2 kgf·m
15.9 ft-lbs
(3) 2P Connector
(4) PTO Clutch Return Cable
W1011677
KiSC issued 08, 2007 A