Kubota G21LD / G21HD Workshop Manual page 307

G21LD · G21HD, WSM
[2] DISMOUNTING AND MOUNTING
Anti-scalp Rollers and Cutting Height Adjusting Dial
1. Park the machine on level ground, and stop the engine.
2. Set the front anti-scalp rollers (1) sideways and at the topmost
position.
3. Set the cutting height adjusting dial to "1" position, and down the
mower.
(1) Front Anti-scalp Roller
Front Link
1. Pull the lever fulcrum fixing pin (2) and turn it clockwise to release
the lock.
2. Push down the link fixing lever (1).
3. Remove the front link (3) from the mower deck.
(When reassembling)
• When attach the front link, make sure the length of the front link.
(See page 9-S5.)
(1) Link Fixing Lever
(2) Lever Fulcrum Fixing Pin
Rear Links and Universal Joint
1. Place the hydraulic lift lever (1) in the "DOWN" position. Push
down the rear links (2) to align with the mower bracket.
2. Disconnect the rear links (2) from the mower deck, pulling the L-
pins (3).
3. Pull back the coupler (4) to unlock.
4. Remove the universal joint (5) from the PTO shaft.
5. Start the engine, and lift the rear links (2).
6. Stop the engine.
(When reassembling)
• Apply grease to the splines and grease nipples of the universal
joint.
• Slide the universal joint back and forward to make sure the
universal joint is locked securely.
• When attach the lift links, make sure the length of the lift links.
(See page 9-S6.)
(1) Hydraulic Lift Lever
(2) Rear Links
(3) L-Pins
(4) Coupler
(5) Universal Joint
Dismounting Mower
1. Turn the front wheel to the left.
2. Pull out the mower deck to the right.
3. Return wheels to straight ahead position.
4. Reset the front anti-scalp rollers to straight ahead position.
(A) LEFT
9-S8
MOWER
W1013013
(3) Front Link
W1013166
(A) Push Down
(B) Pull
W1013384
W1013629
KiSC issued 08, 2007 A