G21LD · G21HD, WSM
(B) Transmission
Trunnion Arm and Journal Bearing
1. Remove the trunnion arm (1).
2. Pry the oil seal (3) off with a screwdriver.
3. Press out the journal bearing (2).
(When reassembling)
• Apply clean field to the journal bearing.
NOTE
• Take care not to damage the housing.
(1) Trunnion Arm
(2) Journal Bearing
Brake Assembly
1. Remove the brake assembly mounting screws (3).
2. Remove the brake assembly (2) with the fulcrum support
assembly (1).
3. Remove the external snap ring (4).
4. Pull out the brake drum (5).
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or its equivalent) to face
of the flange.
• Pushing the brake lever (6) as shown in the figure, tighten the
brake assembly mounting screws.
NOTE
• After assembling the brake assembly, be sure to adjust the
brake pedal play (See page G-23).
(1) Fulcrum Support Assembly
(2) Brake Assembly
(3) Brake Assembly Mounting Screws
2-S19
TRANSMISSION AND REAR AXLE
(3) Oil Seal
(4) External Snap Ring
(5) Brake Drum
(6) Brake Lever
KiSC issued 08, 2007 A
W1031388
W1031669