G21LD · G21HD, WSM
Separating Fender
1. Remove the speed change pedal.
2. Peel the step sheet (1) halfway.
3. Remove the step support mounting screws (2).
4. Remove the step support (5) and rubber bushing (6).
5. Remove the fuel cap (4).
6. Separate the fender from the frame.
(When reassembling)
• Apply grease to the inside of rubber bushing.
• Clean up the step sheet and the step. Apply instantaneous
adhesive on the step sheet as shown in the figure.
• Position the step sheet so that the clearance between the step
sheet and the panel is less than 2.0 mm (0.079 in.) as shown in
the figure.
(1) Step Sheet
(2) Step Support Mounting Screws
(3) Fuel Cap
(4) Step Support
(5) Rubber Bushing
2-S9
TRANSMISSION AND REAR AXLE
A : Less than 2.0mm (0.079 in.)
B : Panel
KiSC issued 08, 2007 A
W1018335