Table of Contents
Advertisement
ENGLISH
Replacing the Channel Fader
The Channel fader may be removed without any disassembly of
the DN-X1100 itself.
1
Channel fader
Pull out the
knob.
2
Remove the five outer screws
fader plate and channel fader bracket assembly from
the front panel.
3
Remove the two screws
fader bracket assembly from chassis.
4
Pull the channel fader bracket assembly forward
and unplug the 4P cable from the connector on the
channel fader printing board.
5
Install the replacement assembly by reversing above
instructions.
Flex Fader Crossfader Slide
Torque Adjustment Procedure
1
Follow the procedure at "Replacing the Crossfader"
to remove the
2
Move the lever so that the head of the
attaching the channel
positioned at the hole in the case.
3
Turn the
and adjust to the desired torque.
attaching the channel
4
Reinstall the
procedure in reverse order.
Crossfader
from the set.
Screw
Screw
using a screwdriver, move the lever
Crossfader
following the removal
........
Screw
Crossfader
Crossfader
is
Advertisement
Table of Contents
