HP D5970A - NetServer - LCII Installation Manual page 40

Chapter 4
Table 4-1 summarizes differences among the operations required for various
types of upgrades. It also lists the section in this chapter that describes each
operation.
Table 4-1. Upgrade Operations for HP NetServer E 60 and LPr
Upgrade to Dual (No Change in Speed)
E 60
Remove terminator
board
Add processor module
Set system switches
Upgrade to New Speed (No Change in Number of Processors)
E 60
Remove existing
processor
module(s)
Install processor
module(s)
Set system switches
E 60
Remove terminator
board
Remove existing
processor module
Install processor
modules
Set system switches
36
LPr
Remove terminator
board
Add processor module
Add VRM
Set system switches
LPr
Remove existing processor
module(s)
Install processor module(s)
Set system switches
Upgrade to Dual at New Speed
LPr
Remove terminator board
Remove existing processor
module
Install processor modules
Add VRM
Set system switches
Installation in E 60 and LPr
Described in
"Removing the Terminator
Board"
"Installing Processor
Modules"
"Installing a VRM in
HP NetServer LPr"
"Setting System Switches"
Described in
"Removing the Existing
Processor Module"
"Installing Processor
Modules"
"Setting System Switches"
Described in
"Removing the Terminator
Board"
"Removing the Existing
Processor Module"
"Installing Processor
Modules"
"Installing a VRM in
HP NetServer LPr"
"Setting System Switches"