Removing A Processor Module Without A Processor Retaining Latch - HP D5970A - NetServer - LCII Installation Manual

Chapter 3

Removing a Processor Module Without a Processor Retaining Latch

To remove a processor module that does not have a processor retaining latch:
1. Press in on each processor module release latch until it remains in (see
Figure 3-5). If the latch does not stay in, you must hold it in while
removing the module.
Processor
Mounting
Bracket
Figure 3-5. Removing a Processor Module Without a Processor
2. Lift up on the processor ejector lever until the processor pops out of the
processor slot (see Figure 3-5).
CAUTION
Do not move the processor ejector lever beyond its limit
(about 25-30 degree angle from the original position). The
ejector lever may break if forced.
Installation in LC 3 and LH 3/3r
Processor Eject Lever
Processor Module
Release Latch (Two Places)
Retaining Latch
19