HP D5970A - NetServer - LCII Installation Manual page 25

Chapter 3
2. Lift up on the processor ejector lever until the processor pops out of the
processor slot (see Figure 3-7).
Figure 3-7. Removing a Processor Module With a Retaining Latch
CAUTION
Do not move the processor ejector lever beyond its limit
(about 25-30 degree angle from the original position). The
ejector lever may break if forced.
3. Remove the processor module from the mounting bracket assembly.
Processor Ejector Lever
Processor Mounting Bracket
Installation in LC 3 and LH 3/3r
21