HP D5970A - NetServer - LCII Installation Manual page 28

Chapter 3
3. Orient the processor module (with its retaining latch mounted) to the
correct processor position (slot), as shown in Figure 3-10.
Processor Module
Secondary Processor
Position
Primary Processor
Position
Figure 3-10. Install the Processor Module with Its Retaining Latch
(Shown for Secondary Processor Module)
CAUTION If the NetServer has only one processor module, it must be
installed in the primary (lower) processor position, and a
terminator board must be installed in the secondary (upper)
position.
If you add a second processor, leave the original processor in
the primary position, and add the new processor to the
secondary position.
24
Installation in LC 3 and LH 3/3r
Processor Mounting Bracket