Reinstall The System Board; Replace Covers And Front Bezel - HP D5970A - NetServer - LCII Installation Manual

Chapter 3
CAUTION Processor modules are designed to operate at only one speed.
This speed is printed on the module. Do not set the system
switches to any speed other than that speed labeled on the
module. Setting the processor speed to another speed may
result in unreliable or intermittent performance. Data
integrity may also be placed at risk if processors are operated
at speeds other than the speed specified on the processor
module.

Reinstall the System Board

Reinstall the system board as described in your NetServer documentation.

Replace Covers and Front Bezel

Do the following:
Replace the covers and front bezel. If the NetServer was mounted in a
rack enclosure, also replace the NetServer in the rack.
If you upgraded to Pentium III processor modules, attach the Pentium III
label to a corner of the front bezel.
Connect the AC power cord and all cables.
Refer to your NetServer documentation for instruction. For a NetServer in a rack,
also refer to the rack documentation.
CAUTION
Never operate the NetServer, even for a short time, without
first installing all covers and the front bezel. Operating the
system without all covers in place reduces critical cooling
airflow over some components, such as hard disk drives,
circuit boards, and processor modules. Operating the system
without all covers in place may result in failure of these
components.
Next, go to Chapter 5, "Verification," to ensure that the processor upgrade was
completed successfully.
Installation in LC 3 and LH 3/3r
33