View The Readme File - HP D5970A - NetServer - LCII Installation Manual

Chapter 2
2. Compare the version number on the status report with the version number
on the HP NetServer Navigator CD-ROM, as shown in Figure 2-1.
Version Number
3. If you do not have the latest version, obtain it as instructed by the ordering
information on the status report.

View the Readme File

The Readme file on the HP NetServer Navigator CD-ROM contains the most
recent information that may not have been available at the time this guide was
printed. It is important to check this file before proceeding with the installation.
View the Readme file, as follows:
1. Turn on the display monitor and the HP NetServer, and insert the
HP NetServer Navigator CD-ROM into the drive. Turn the power off,
wait 10 seconds, and turn the power on again. If HP NetServer Navigator
fails to start, follow the instructions on the screen.
2. When HP NetServer Navigator starts, you may need to set the language
and the time and date. Follow the instructions on the screen. You can also
change the language of the BIOS when prompted.
When the HP NetServer Navigator starts, you may see an error message
that the version of BIOS on the NetServer Navigator CD-ROM is
newer than the BIOS detected in your NetServer.
If this message does not appear, your BIOS contains the proper BIOS
for the processors installed, and it does not need updating for this
purpose.
6
Figure 2-1. CD-ROM Version Number
Preparation
XXXX XXXX