Setting System Switches; Replace The Cover - HP D5970A - NetServer - LCII Installation Manual

Chapter 4
2. Insert the terminator board into the secondary processor position.
3. Verify that the terminator board is installed completely in the slot.

Setting System Switches

After installing processors, verify that the system switches are set to the correct
processor clock speed (frequency). If the switches are not set correctly, set them
accordingly.
To set the system switches:
1. Locate the system switches on the system board (see Figure 4-1 or 4-2).
2. Look up the appropriate switch settings for the speed (frequency) of the
processor modules installed in the NetServer. Tables of system switch
settings are located next to the system switches and on the Technical
Reference Card.
3. Set the switches accordingly.
CAUTION Processor modules are designed to operate at the speed that is
printed on the module. Do not set the processor speed
switches to a different speed. Setting the processor speed to
another speed may result in unreliable or intermittent
performance. Data integrity may also be placed at risk if
processors are operated at speeds other than that specified on
the processor module.

Replace the Cover

NOTE
In an HP NetServer E 60, reposition the cooling duct over the
processor modules, and snap it into place.
1. Reinstall any accessory boards that you removed.
2. Replace the cover.
46
Installation in E 60 and LPr