Installing A Vrm - HP D5970A - NetServer - LCII Installation Manual

Chapter 3

Installing a VRM

One voltage regulator module (VRM) must be installed for each processor
module installed. If only one processor module is installed, a VRM must be
installed in the primary (lower) VRM socket, next to the primary processor.
To install a VRM:
1. Orient the VRM as shown in Figure 3-13. The component side of the
VRM faces the center of the system board. Do not touch the components
on the VRM.
VRM for
Secondary
Processor
Module
Figure 3-13. Installing a VRM for HP NetServer LC 3 and LH 3/3r
(Details of Processor Modules May Vary.)
28
Installation in LC 3 and LH 3/3r
VRM for
Primary
Processor
Module
Primary Processor
Module
Secondary Processor
Module