Remove Ebipa; Set Ebipa - HP Xw460c - ProLiant - Blade Workstation User Manual

CAUTION:
•
Command:
ENABLE EBIPA {SERVER|INTERCONNECT} [ALL | <bay number> [{ , | - } <bay
number>]]
•
Description:
Enables the Onboard Administrator to provide IP addresses to the devices in the bays using DHCP.
If you do not specify any bay numbers, then EBIPA is enabled for all bays.
DHCP traffic from iLO and the switch modules can no longer go outside the enclosure.
This causes a reset of the iLO, which causes it to attempt to get an IP address. The interconnect is
power-cycled.
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
Before using this command you must set up the EBIPA settings. This includes setting the initial IP
address, the netmask, and the default gateway.

REMOVE EBIPA

•
Command:
REMOVE EBIPA {SERVER|INTERCONNECT} DNS <ip address>
•
Description:
Removes the DNS server specified by the <ip address> from the list of DNS servers for either SERVER
bays or INTERCONNECT bays
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
The <ip address> and must be in the form ###.###.###.###, where each ### ranges from 0 to
255.

SET EBIPA

•
Command:
SET EBIPA {SERVER|INTERCONNECT} {NETMASK <netmask>|GATEWAY <gateway>|NTP
{PRIMARY|SECONDARY} <ip address> |DOMAIN "<domain name>" |<ip address>
{<netmask>|[<netmask>]} {ALL|<bay number> [{ , | - } <bay number>]}}
•
Description:
Sets EBIPA settings, including starting IP address, net mask, default gateway, primary or secondary
NTP server (interconnects only), and domain name for the specified bay type. If no bays are
specified when setting the < IP address>, then all the bays are assigned an IP address in the range
starting from the <ip address>. The keyword NONE can be used in the place of <ip address> or
<gateway> to clear the IP address.
This command cycles power to the interconnect and causes a loss of connectivity.
Enclosure Bay IP Addressing commands 50