Set Server Boot Once; Set Server Powerdelay - HP Xw460c - ProLiant - Blade Workstation User Manual

Bay specific
•
Restrictions:
You must have access to the specified bay number.
o
This command is not applicable to storage blades
o
This command is not applicable to HP Integrity server blades.
o
This setting is only valid on present blades and cleared if the blade is removed.
o

SET SERVER BOOT ONCE

•
Command:
SET SERVER BOOT ONCE {NORMAL | HDD | PXE | RBSU} {ALL | <bay number> [{
- | , } <bay number>]}
•
Description:
Stores a setting for the IPL to bypass to the servers specified at the next reboot
o
Sets the boot device to be used on the next boot of the bays specified.
o
•
Access level/Bay level:
Administrator, operator
Bay specific
•
Restrictions:
You must have access to the specified bay number.
o
This command is not applicable to storage blades.
o
This command is not applicable to HP Integrity server blades.
o
This setting is valid only on present blades and is cleared if the blade is removed.
o

SET SERVER POWERDELAY

•
Command:
SET SERVER POWERDELAY {ALL | <bay number> [{ - | , } <bay number>]}
{number of seconds to delay power | NOPOWERON}
•
Description:
Set the PowerDelay status for the specified server or range of servers. If the delay is zero, the delay
has no effect on the device. If the delay is NOPOWERON, the device cannot poweron until all devices
have completed their delays.
•
Access level/Bay level:
Administrator
Bay specific
•
Restrictions:
You must have access to the specified bay number.
Blade management commands 98