SET SNMP COMMUNITY
•
Command:
SET SNMP COMMUNITY {READ | WRITE} "<community name>"
•
Description:
Sets the community name for the read or write SNMP community. If a blank write community name is
given, then SNMP set commands are disabled until a non-empty community name is given.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
The write <community name> must be no more than 20 characters long, and the read
o
<community name> must be 1 to 20 characters long.
All printable characters are valid.
o
The default read community name is public.
o
The default write community name is public.
o
SET SNMP LOCATION
•
Command:
SET SNMP LOCATION "<location>"
•
Description:
Configures the SNMP location of the enclosure. The default location is blank.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
The <location> must be no more than 20 characters long. Valid characters are all alphanumeric, the
underscore (_), the dash (-), and spaces.
SHOW NETWORK
•
Command:
SHOW NETWORK
•
Description:
Displays:
Enclosure
o
DHCP state
o
Dynamic DNS state
o
IP address subnet mask
o
Gateway address
o
Primary and secondary DNS addresses
o
Enclosure network configuration commands 66