HP Xw460c - ProLiant - Blade Workstation User Manual page 10

Pin Name
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Use any standard communication software to launch a terminal emulation session with the following
2.
parameters:
Parameter Value
Transmission rate 9600 bps
Data bits 8
Parity None
Stop bits 1
Protocol None
When prompted, enter a valid user name, and then press Enter.
3.
Enter a valid password, and press Enter. The CLI command prompt appears.
4.
Enter commands for the Onboard Administrator.
5.
To terminate the terminal session, enter Exit at the prompt.
6.
Signal direction Description
<<-- Receive data
-->> Transmit data
-->> Data terminal ready
System ground
<<-- Data set ready
-->> Request to send
<<-- Clear to send
<<-- Ring indicator
Accessing the command line interface 10