HP T5145 - Thin Client - Tower User Manual page 149

HP 700-92/96 Emulation
Start column
Factory default: 1
This enables you to specify the start column for transmitted data
when no logical start-of-text pointer is present and the Return or
Enter keys are pressed in or mode.
Modify Line Modify All
Usually a start-of-text pointer is automatically generated to desig-
nate the leftmost character in the current line if it is the last line of
data in display memory. This pointer will remain in display memory
until the line is deleted. If the line has no start-of-text pointer, data
transmission will begin at the start column specified by this option.
The column range is from 1 to 80 inclusive.
Note: The setting of this option may be temporarily redefined using
one of the Margin/Tab/Col function keys. Refer to the section "Mar-
gins, Tabs & Start Column" on page 118 for details.
Return definition
Factory default: ^M (i.e. CR)
This enables you to define the function of the Return key. Up to two
characters may be used to define the key. If a second character is a
space, it will be ignored.
To change the current definition, delete the definition displayed in
the text box and type in the new one, either as the control key char-
acter equivalent or the decimal value of the ASCII character.
For example, the default code for the Return key function, CR
(carriage return), can be entered by typing the characters ^ and M,
representing the keys Ctrl + M which, when pressed together would
generate the CR code.
Decimal values are entered as three-digit numbers immediately pre-
ceded by an underscore character. Values with only two digits must
be preceded by a zero. For example, the decimal value of CR is 13,
so this would be entered as _013.
Setup Options 133