Cable Management Tray; Seismic Brace - HP BladeSystem c7000 Maintenance And Service Manual

6. Remove the DC input module.
To replace the component, reverse the removal procedure.

Cable Management Tray

Remove the screws, and slide the cable management tray out of the mounting rails.
NOTE: If you have any difficulty sliding the cable management tray out of the mounting rails,
loosen the screws that hold the rail brackets and then slide the tray out.
To reinstall the component, reverse the procedure.

Seismic Brace

CAUTION:
To remove the component:
1. Remove the screws from the front brackets.
The seismic top brace weighs 35 lbs, use caution when moving it.
Cable Management Tray 13