Identifying Integrated Administrator Components; Determining The Integrated Administrator's Initial Ip Address - HP BladeSystem bc2000 - Blade PC User Manual

CAUTION:
Administrator cannot gracefully shut down a blade PC. This condition may result in the permanent loss
of critical data.

Identifying Integrated Administrator Components

Each HP PC Blade Enclosure interconnect tray ships with the Integrated Administrator module already
installed and provides external connectivity using two connectors on the rear panel.
CAUTION:
and are not designed to accept a 10/100 Ethernet connector.
Table 3-1 Integrated Administrator Rear Panel Components
Item
1
2
3
4
5
Determining the Integrated Administrator's Initial IP
Address
HP recommends that you connect a local client device, such as a laptop computer, to the console (serial)
connector in order to determine the initial IP address used by the network to recognize the Integrated
Administrator. After using that IP address to access the Integrated Administrator locally using the
console (serial) connector, you can use the Integrated Administrator default values to complete the initial
configuration.
10 Chapter 3 Getting Started
Without the blade PC health driver or an ACPI-compliant operating system, the Integrated
Do not plug anything into the enclosure link connectors. They are reserved for future use
Description
Management (10/100 Ethernet) connector for remote access through a Web-based user interface, Telnet,
or Secure Shell.
Console (serial) connector for local access to the command line interface using a laptop computer.
Integrated Administrator reset button.
Integrated Administrator health LED
Enclosure Unit Identification button/LED
ENWW