HP BladeSystem bc2000 - Blade PC User Manual page 64

(continued)
ENABLE SECURESH
ENABLE SNMP
ENABLE TELNET
ENABLE WEB
REMOVE SNMP
TRAPRECEIVER
<ip address>
SET DNS
<primary address>
{<secondary address>}
SET GATEWAY
<ip address>
SET IPCONFIG
[DHCP {DYNAMICDNS} |
STATIC <P address>
<netmask>]
SET SNMP COMMUNITY
[READ | WRITE] <community
name>
56 Chapter 5 Command Line Interface
Enables Secure Shell account to the Integrated Administrator. Only enclosure
Enables SNMP support for the Integrated Administrator.
Enables Telnet access to the Integrated Administrator.
Enables HTTP and HTTPS access to the Integrated
Administrator.
Removes an IP address from the list of systems to receive
SNMP traps
Sets the primary and secondary DNS server addresses
These servers are only used if the system is currently
configured to use a static IP address.
Sets the network default gateway
This gateway is only used if the system is configured to use a
static IP address.
Sets up the Integrated Administrator IP configuration
The gateway and DNS addresses are cleared. The optional
DYNAMICDNS argument enables Dynamic DNS.
Sets the community name for the read or write SNMP
community
The default names for the read and write community are
public and blank, respectively. If a blank write community
name is given, SNMP set commands are disabled until a non-
empty community name is given.
administrators may execute
this command.
Only enclosure
administrators may execute
this command.
Only enclosure
administrators may execute
this command.
Only enclosure
administrators may execute
this command.
Only enclosure
administrators may execute
this command.
The IP address must be in the
form ###.###.###.### where
### ranges from 0 to 255.
Only enclosure
administrators may execute
this command.
The IP address must be in the
form ###.###.###.### where
### ranges from 0 to 255.
Only enclosure
administrators may execute
this command.
The IP address must be in the
form ###.###.###.### where
### ranges from 0 to 255.
Only enclosure
administrators may execute
this command.
The IP address must be in the
form ###.###.###.### where
### ranges from 0 to 255.
Only enclosure
administrators may modify
another user's contact
information.
The write <community name>
must be 1-20 characters long,
and the read <community
name> must be 1-20
characters long. Both can
include alphanumeric, dash,
and underscore characters.
The default read community
name is public. The default
write community name is
blank.
ENWW