HP BladeSystem bc2000 - Blade PC User Manual page 74

Table 5-9 Functions Exclusive to the Command Line Interface — Enclosure Management Commands
(continued)
SHOW BAY LIST [ALL |
<group name>]
SHOW SYSLOG BAY <bay
number>
ADD IPMANAGER <IP
address>
DISABLE ALERTMAIL
DISABLE IPSECURITY
DISABLE NTP
ENABLE ALERTMAIL
ENABLE IPSECURITY
ENABLE NTP
REMOVE IPMANAGER <IP
address>
SET ALERTMAIL [MAILBOX
| SENDERDOMAIN |
SMTPSERVER]
SET NTP [PRIMARY |
SECONDARY | POLL]
SHOW NETWORK
SET ENCLOSURE SERIAL
{NUMBER} <serial number>
66 Chapter 5 Command Line Interface
This command may require a firmware upgrade for the BIOS
ROM of certain HP blade PCs.
Displays the assigned to group, remote console user, and
blade PC name for each bay in a particular group if a group
name is specified or all bays if ALL is specified.
Displays the syslog of a specified blade with 22 lines per
screen.
Typing q quits the command; any other key shows the next
screen if more information is available to display. The system
log of the blade PC is not stored between reboots, so the
information only includes what has taken place since the last
power on of the Integrated Administrator.
Typing c displays the System Log continuously without page
breaks.
Adds an IP address to the list of clients allowed to connect to
Integrated Administrator.
Disables sending e-mail for Integrated Administrator alerts.
Allows all clients to connect to Integrated Administrator.
Disables automatic updates of the date and time to the
Integrated Administrator.
Enables sending e-mail for Integrated Administrator alerts.
Restricts clients from being able to connect to Integrated
Administrator.
Enables automatic time and date updates to Integrated
Administrator.
Removes the IP address from the list of clients allowed to
connect to Integrated Administrator.
Sets the e-mail address of the alert recipient, the domain name,
and the mail server address.
Sets the IP address of the primary and secondary NTP servers.
Also sets the frequency of the updates.
Displays the DHCP state, Dynamic DNS state, IP address,
subnet mask, gateway address, primary and secondary DNS
addresses, MAC address, HTTP and HTTPS server status,
SNMP status, Secure Shell status, Telnet status, NTP status,
NTP primary and secondary server address, NTP poll interval,
NTP last update time, IP security configuration, AlertMail
status, AlertMail mailbox, SMTP server address and sender
domain of the enclosure.
Allows modification of the serial number reported by the
enclosure information.
The command line displays
the remote console user.
All
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
Only enclosure administrators
may execute this command.
ENWW