Troubleshooting - Elan V883 Installation Manual

E L A N H O M E S Y S T E M S

6. Troubleshooting

General
SYMPTOM
No power up.
IR Control
SYMPTOM
No source or zone selected
from IR controller (keypad,
hand-held remote, etc.).
IR LED does NOT flash
when button pressed.
No source or zone selected
from IR controller (keypad,
hand-held remote, etc.).
IR LED DOES flash when
button pressed.
Intermittant or no source or
zone control from IR control-
ler (keypad, hand-held
remote, etc.). IR LED flickers
or is lit constantly.
Incorrect source and/or zone
selected.
© ELAN Home Systems 2006 • All rights reserved.
CAUSE
1. No AC power.
1. Blown fuse.
CAUSE
1. IR controller not programmed.
2. IR signal path wiring bad.
1. Incorrect IR commands
programmed (not V883
commands).
2. UNIT ID DIP switches incorrect.
IR flooding.
Incorrect V883 IR commands
programmed.
V883
INSTALLATION MANUAL
SOLUTION
Connect Power Cord to AC outlet.
Check AC circuit breaker.
Replace fuse w/ T0.4AL type fuse
(T0.2AL for 240V version).
SOLUTION
Program IR controller.
Verify IR signal path wiring.
Check keypads, IR sensors, IR
distribution blocks, V883 IR Input
jack, IR emitters, etc.
Verify/correct IR programming.
Verify/correct DIP switches.
Check IR receivers or V883 front
IR sensor for ambient light or
plasma TV flooding.
Verify/correct IR programming.
Page 23