Dip Switch Settings 1 - Elan V883 Installation Manual

V883
INSTALLATION MANUAL
DIP Switch Settings - UNIT ID
Consult the chart below to determine the correct UNIT ID DIP switch settings. These
settings determine which output commands a particular unit responds to. V883s set
to UNIT ID 1 will respond to commands specifying Outputs 1-8, UNIT ID 2 responds
to commands specifying Outputs 9-16, etc.
Unit ID Zones
1 (Factory Default) 1-8
2 9-16
3 17-24
4 25-32
UNIT ID
UNIT 1
1 2 3
(Factory Default)
Front Panel Unit ID Designations
The Output/Input LED indicators on the front panel display the V883's Unit ID
designation. A decimal point located in the display window indicates the Unit ID
for each chassis as shown below.
Unit
ID #1
Unit
ID #3
Page 10
Switch #1 (left)
OFF/UP
OFF/UP
ON/DOWN
ON/DOWN
UNIT ID UNIT ID
UNIT 2 UNIT 3
1 2 3
1 2 3
Unit
ID #2
Unit
ID #4
E L A N H O M E S Y S T E M S
Switch #2 (center)
OFF/UP
ON/DOWN
OFF/UP
ON/DOWN
UNIT ID
UNIT 4
1 2 3
© ELAN Home Systems 2006 • All rights reserved. ©