Kyocera KM-C2030 Operation Manual page 20

1.3 Names of Control Panel Parts and Their Functions
No. Part Name
9 [Panel Reset] key
10 [C] (clear) key
11 [Stop] key
12 [Start] key
13 Control panel release lever
14 [Enlarge Display] key
15 Touch panel contrast-
adjusting dial
* Job: Any set of consecutive operations, such as those for making copies, scans or computer printouts
Description
• Press to reset all copy modes and functions to their default
settings. (All selected settings* are canceled.)
• The current job is canceled.
*Stored zoom ratios, stored job settings, and interrupted or
delayed jobs are not canceled.
• Press to reset the number of copies to "1".
• Press to erase a setting, such as the zoom ratio or size,
selected using the keypad.
• The scanned image is erased.
• Press to stop a copy operation.
• Scanning of a document is stopped.
• Press to start a job.
• If this key is pressed during a continuous copy operation,
scanning for the job begins. (Queued copy) See p. 6-2.
• Press to continue an interrupted copy job.
• If this key is pressed while the copier is warming up, scanning
for the job begins. (Queued copy) See p. 1-16.
• The key indicator lights up in green to indicate that jobs can
be queued. The key indicator lights up in orange to indicate
that no jobs can be queued.
• Use when adjusting the angle of the control panel.
• Pull the release lever, and then push down on the control
panel to adjust its angle.
• Will be used to enlarge the display. (Currently not available)
• Use to adjust the contrast of the touch panel.
1
1-13