Troubleshooting Tables - Kyocera KM-6230 Instruction Handbook Manual

4. Troubleshooting tables

If trouble occurs, refer to the tables below to carry out corrective procedures. If the trouble persists, contact the service representative for your copier.
Trouble
Nothing lights on the
operation panel even though
the main switch is ON ( | ).
No copies come out even
though the Start key was
pressed.
The finished copies are
blank.
The finished copies are too
light.
Check point
Is the power plug connected to an AC
outlet?
Is there a message in the message display?
Confirm the appropriate action based on the
Were the originals set correctly ?
Is the copier in the auto exposure mode?
Is the copier in the manual exposure mode?
Use the copy exposure adjustment keys to
Is a message displayed that tells you to add
toner?
Is the paper damp or wet?
Section 10 TROUBLESHOOTING
Procedure
Connect the plug to an AC outlet.
message, and perform the corresponding
procedure.
When setting originals in the DF, set them
face up.
When setting an original on the platen, set it
face down.
To adjust the overall exposure level, perform
the "Auto exposure adjustment" procedure.
adjust the exposure as appropriate.
To adjust the overall exposure level, perform
the "Manual exposure adjustment" proce-
dure.
Add toner.
Replace it with new paper.
Page
10-1
3-4
3-5
8-15
4-1
8-16
3-5
3-1
10-18