Auto Selection Mode; Setting Originals On The Platen; Adding Toner - Kyocera KM-6230 Instruction Handbook Manual

Section 3 PREPARATIONS
3-5

5 Auto selection mode

The copier will automatically detect the size of each original and select paper of that
same size to copy onto.
POINT OF INFORMATION
• A maximum of 50 originals can be set in DF at one time with this mode.
• The size of originals that can be used in this mode is limited to 11" x 17" and
11" x 8-1/2" (A3 and A4) and all originals must be of the same width.
1. Touch the "Added" key.
The function select screen will appear.
2. Touch the "Auto Selection" key. (If that key is not displayed, touch the " " key or the
" " key until it is displayed.)
The touch panel will return to the basic screen.

6 Setting originals on the platen

To make copies from originals that cannot be set in the DF (books, magazines, etc.), lift
open the DF and set one original at a time on the platen.
1. Hold the DF open/close handle and lift the DF open.
* Before opening the DF, remove any originals that are on the original table and the
original ejection table to prevent them from falling off the DF when it is opened.
2. Set the original face down on the platen and align it with original size indicator lines.
3. Hold the DF open/close handle and close the DF.
IMPORTANT!
Avoid placing excessive pressure on the platen when closing the DF. Too much pressure
on the platen may cause the glass to break.
CAUTION
DO NOT leave the document feeder open as there is a danger of personal
injury.

3. Adding toner

Add toner when "Add toner to resume copying." appears in the message display.
* DO NOT add toner unless this message is displayed.
* Touch the "? Toner" key on the touch panel to display the procedure for adding toner.
CAUTION
Do not incinerate toner and toner containers. Dangerous sparks may cause
burns.