Setting Originals; What Is The Df For; Originals That Can Be Set In The Df; Cautions When Using The Df - Kyocera KM-6230 Instruction Handbook Manual

2. Setting originals

1 What is the DF for?

The DF (Document Feeder) automatically feeds and scans each original, one by one, for
copying. When you make copies from two-sided originals, it will automatically turn the
originals over in order to copy the reverse side as well.

2 Originals that can be set in the DF...

• Sheet originals
• Thickness:
One-sided originals: between 35 g/m
Two-sided originals: between 50 g/m
• Size: Max. 11" x 17" (A3) - Min. 5-1/2" x 8-1/2" (A5R)
• Number of sheets:
100 sheets (11" x 8-1/2" [A4] or smaller [75 g/m
70 sheets (8-1/2" x 14" [B4] or larger [75 g/m
(However, 30 sheets maximum when using the auto selection mode)

3 Cautions when using the DF

DO NOT set originals of the follow types in the DF. In addition, when using perforated
sheets or originals with punch holes, DO NOT insert the end with the perforations or
holes first.
• Transparencies
• Carbon paper, crumpled originals or originals with strong folds, and soft originals such
as vinyl
• Originals which are not rectangular, wet originals, and originals with adhesive tape or
glue
• Originals with clips or staples (In order to use such originals, remove the clips or staples
and straighten any crumples or folds before using them.)
• Clippings or originals with very slippery surfaces
• Originals with wet correction fluid
• Originals with folds (If you must use such originals, smooth out the folded portions
before setting them in the DF.)

4 Setting originals in the DF

1. Adjust the original insert guides to fit the size of the originals.
* Before setting any new originals, remove any originals that are remaining on the
original ejection table. If ejected originals are left on the original ejection table, they
may cause other originals to misfeed.
2. Arrange the originals in order and set them face up (first page face up for two-sided
originals) onto the original table. The original set indicator will light green. If the indica-
tor does not light, reset the originals in the DF.
IMPORTANT!
DO NOT set more originals than indicated on the sticker that is attached to the rear
original insert guide. If more than the acceptable number of originals is set, the originals
may not feed properly.
* When setting large size originals such as 8-1/2" x 14" and 11" x 17" (B4, Folio, A3),
open the original ejection guide to prevent the ejected originals from sliding off the
original ejection table.
IMPORTANT!
When copying from two-sided originals, each original will be ejected temporarily out of
the original reversing cover before being turned over. DO NOT touch or attempt to re-
move any original at this time as it will cause a misfeed error.
Section 3 PREPARATIONS
2 2
- 160 g/m
2 2
- 120 g/m
2 2
or 80 g/m ])
2 2
or 80 g/m ])
3-4