Copying In The Hole Punch Mode - Kyocera KM-6230 Instruction Handbook Manual

5. Remove all of the finished copies from the Sort tray.
5

5 Copying in the Hole Punch mode

5 5 5
Copies can be automatically hole punched.
1. Press the Punch key until the indicator that corresponds to the desired number of
holes is lit [either 2- or 3-hole punch]. The Hole Punch mode is now selected.
* The Hole Punch mode may be used in combination with the Sort mode, the Staple-
Sort mode or the Group mode.
POINT OF INFORMATION
Acceptable copy paper weight:
45 g/m 2 - 120 g/m 2
* Hole punching will be accomplished as shown in the illustration at left (as viewed from
the front of the copies).
IMPORTANT!
The position of the holes on each page may differ very slightly due to the fact that holes
are punched in one sheet at a time.
2. Set the originals to be copied.
3. Set the desired paper size and number of copy sets to be made, etc.
POINT OF INFORMATION
Acceptable copy paper sizes for each hole punch style:
• 2-hole punch: 8-1/2" x 14", 8-1/2" x 11"
• 3-hole punch: 11" x 17", 11" x 8-1/2"
(45 g/m 2 - 120 g/m 2 weight standard copy paper)
4. Press the Print key. The copies will be automatically hole punched and ejected onto
the Non-sort tray.
5. Remove all of the finished copies from the Non-sort tray.
Section 9 OPTIONAL EQUIPMENT
9-4