Rear Panel; Specifications - Panasonic AV-HS60C3G Operating Instructions Manual

Specifications

Display position
Upper right
Bottom
2 <WFM VECT> button
Each time the button is pressed when the menu display is split, the WFM (waveform monitor) and VECTOR (vectorscope) displayed at the upper
right of the screen are switched.
@
NOTE
t When anything other than [DISP] is selected using the <SYS> button → [SYSTEM] → [Display] tab → [Video Codec] column → [Target] item, the
image selected in the DISP bus, the WFM, or the VECTOR is not displayed.
t Image, WFM, and VECTOR are not displayed in the Menu Panel AV-HS60C3 connected to the sub control panel.

Rear panel

1 <CONTROL PANEL> terminal (connector: DVI-D/signal: independent signal)
Connects the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4.
f This is the dedicated interface for connection with the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4 (optional). Do not connect with DVI
output devices.
Specifications
Power supply
DC e 12 V/0.54 A
* Supplied from AV-HS60C1/AV-HS60C2/AV-HS60C4 using supplied cable
Power consumption
6.48 W
indicates safety information.
<CONTROL PANEL> terminal
Ambient operating temperature
Humidity
Dimensions (W×H×D)
Mass
10
The WFM (waveform monitor) or VECTOR (vectorscope) for the video selected in the DISP bus is displayed.
The menu will be displayed.
Used only for the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4
f Connector: DVI-D
f Because an independent signal format is used, DVI-D source cannot be displayed.
f Cannot be used concurrently with a DVI-D monitor connected to the <DVI-D> terminal of the Control Panel AV-HS60C1/
AV-HS60C2/AV-HS60C4. Set the display selector switch of the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4 to
the <MENU PANEL> terminal side.
0 °C to 40 °C (32 °F to 104 °F)
10% to 90% (no condensation)
290 mm×177 mm×46.1 mm (11-13/32 inches×6-31/32 inches×1-13/16 inches) (excluding protrusions)
4RU
AV-HS60C3: Approx. 1.7 k] (3.7 lbs.) (excluding accessories)
Display content
1