Vertical Service Activation Codes Section - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference
Regional page
Cisco Small Business ATA Administration Guide
CPC Duration
Voice tab > Regional page >

Vertical Service Activation Codes section

Vertical Service Activation Codes are automatically appended to the dial-plan.
There is no need to include them in dial-plan, although no harm is done if they are
included.
Call Return Code
Call Redial Code
Blind Transfer Code Begins a blind transfer of the current call to the extension
Call Back Act Code Starts a callback when the last outbound call is not busy.
Call Back Deact
Code
Call Back Busy Act
Code
Cfwd All Act Code
Duration in seconds for which the tip-to-ring voltage is
removed after the caller hangs up. After that, tip-to-ring
voltage is restored and dial tone applies if the attached
equipment is still off-hook. CPC is disabled if this value is
set to 0. Range: 0 to 1.000 second. Resolution is 0.001
second.
The default is 0 (CPC disabled).
This code calls the last caller.
The default is *69.
Redials the last number called. This field is not found in the
PAP2T.
The default is *07.
specified after the activation code.
The default is *98.
The default is *66.
Cancels a callback.
The default is *86.
Starts a callback when the last outbound call is busy. This
field is only found in the PAP2T.
The default is *05
Forwards all calls to the extension specified after the
activation code.
The default is *72.
B
148