Regional Page - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference

Regional page

Regional page
Cisco Small Business ATA Administration Guide
Hunt Policy
You can use the Voice tab > Regional page to localize your system with the
appropriate regional settings. With some variations, depending on the model, this
page includes the following sections:
•
"Call Progress Tones section" section on page 140
•
"Distinctive Ring Patterns section" section on page 142
•
"Distinctive Call Waiting Tone Patterns section" section on page 143
•
"Distinctive Ring/CWT Pattern Names section" section on page 144
•
"Ring and Call Waiting Tone Spec section" section on page 145
•
"Control Timer Values (sec) section" section on page 146
•
"Vertical Service Activation Codes section" section on page 148
•
"Vertical Service Announcement Codes section (SPA2102, SPA8000)"
section on page 154
•
"Outbound Call Codec Selection Codes section" section on page 154
•
"Miscellaneous section" section on page 156
This parameter can be used to modify the hunting behavior
for trunk lines, based on the call state of the trunk lines that
are specified in the Voice tab > Trunk page, Contact List
field. The following options are available:
•
onhook only: An incoming call is directed to a specified trunk
line only if the call state is onhook.
•
any state: An incoming call is directed to any specified trunk
line without regard to the call state.
B
139