Line Enable Section; Nat Settings Section - Cisco Small Business SPA2102 Administration Manual

ATA Voice Field Reference
PSTN Line page (SPA3102)
Cisco Small Business ATA Administration Guide
•
"Network Settings section" section on page 200
•
"SIP Settings section" section on page 201
•
"Proxy and Registration section" section on page 204
•
"Subscriber Information section" section on page 205
•
"Audio Configuration section" section on page 206
•
"Dial Plans section" section on page 210
•
"VoIP-To-PSTN Gateway Setup section" section on page 210
•
"VoIP Users and Passwords (HTTP Authentication) section" section on
page 212
•
"FXO (PSTN) Timer Values (sec) section" section on page 213
•
"PSTN Disconnect Detection section" section on page 215
•
"International Control (Settings) section" section on page 218
Voice tab > PSTN Line page (SPA3102) >

Line Enable section

Line Enable
PSTN Contact List
Voice tab > PSTN Line page (SPA3102) >

NAT Settings section

NAT Mapping
Enable
To enable this line for service, select yes. Otherwise, select
no.
The default is yes.
Select the appropriate list: None, Phone 1+2, Phone 1, or
Phone 2. The default is Phone1+2.
To use externally mapped IP addresses and SIP/RTP ports
in SIP messages, select yes. Otherwise, select no.
The default is no.
B
199