Setting Up Your Ata Device; Setting Up Your Ata Device" Section - Cisco Small Business SPA2102 Administration Manual

Basic Administration and Configuration

Setting up Your ATA Device

STEP 2
STEP 3
Setting up Your ATA Device
Cisco Small Business ATA Administration Guide
Make a note of the IP address that is announced.
If the administration computer is connected to the Ethernet port of the ATA
NOTE
device, the default IP address is 192. 1 68.0. 1 .
Use the administration computer to install the latest firmware:
a. Extract the Zip file, and then run the executable file to upgrade the firmware.
Firmware Upgrade Warning
b. When the
c. In the next window that appears, enter the IP address of the ATA device, and
then click OK.
Confirm Upgrade
d. In the
product number appear. Then click Upgrade.
e. A progress message appears while the upgrade is in progress. The success
window appears when the upgrade is completed. The device reboots.
f. Click OK to close the confirmation message.
g. To verify the upgrade, point the web browser to the IP address of the ATA
device. Check the
show the firmware version that you installed.
You may need to refresh your browser to display the updated page
NOTE
reflecting the new version number.
After installation and basic configuration of your ATA device, you will use the
administration web server to finish your configuration.
ATA devices support two levels of administration privileges: Administrator and
User. Both privileges can be password protected.
window appears, click Continue.
window, verify that the correct device information and
Router > Status
page. The
Software Version
field should
2
38