Cisco Small Business SPA2102 Administration Manual page 41

Basic Administration and Configuration
Using the Administration Web Server
STEP 3
STEP 4
STEP 5
Cisco Small Business ATA Administration Guide
Complete the WAN configuration for DHCP, static IP addressing, or PPPoE.
For DHCP:
a. Select DHCP from the
b. If you use a cable modem, you may need to configure the MAC Clone Settings.
(Contact your ISP for more information.)
c. If your service uses a specific PC MAC address, then select yes from the
Enable MAC Clone Service
d. Then enter the PC's MAC address in the
For Static IP Addressing:
a. Select Static IP from the
b. In the Static IP Settings section, enter the IP address in the
subnet mask in the
Gateway
field.
c. In the Optional Settings section, enter the DNS server address(es) in the
Primary DNS
and optional
For PPPoE:
a. Select PPPoE from the
setting for most DSL users.
b. Enter the values provided by the ITSP in the following fields:
• PPPoE Login Name
• PPPoE Login Password
• PPPoE Service Name
Click Submit All Changes. The ATA device reboots.
To verify your progress, click the Router tab and then click Status. Under
Status WAN Connection Type
, confirm the
Gateway Primary DNS
, and
Connection Type
setting.
Connection Type
NetMask
field, and the default gateway IP address in the
Secondary DNS
Connection Type
Current IP
,
.
drop-down menu.
Cloned MAC Address
drop-down menu.
Static IP
fields.
drop-down menu. This is the correct
Current Netmask
,
2
field.
field, the
System
Current
,
41