Optional Settings Section - Cisco Small Business SPA2102 Administration Manual

ATA Routing Field Reference
WAN Status page
Cisco Small Business ATA Administration Guide
Router tab > WAN Setup page >

Optional Settings section

HostName
Domain
Primary DNS
Secondary DNS
DNS Service Order
DNS Query Mode
Primary NTP Server
Secondary NTP Server The IP address or name of the secondary NTP server.
The host name of the ATA device.
The network domain of the ATA device.
The DNS server that is used by the ATA device.
NOTE: When DHCP is enabled, you can enter the IP
address of a DNS server in addition to DHCP-supplied
DNS servers. When DHCP is disabled, enter the
primary DNS server. The default is 0.0.0.0.
Sets the secondary DNS server to take over if
problems are discovered with the Primary DNS server.
NOTE: When DHCP is enabled, you can enter the IP
address of a primary or secondary DNS server in
addition to DHCP-supplied DNS servers. When DHCP is
disabled, enter the primary and secondary DNS server.
The default is 0.0.0.0.
The method for selecting the DNS server: Manual
(enter the IP address of the DNS server manually; that is
do not look at the DHCP-supplied DNS table), Manual/
DHCP, and DHCP/Manual.
The mode of DNS query: parallel or sequential.
NOTE: With parallel DNS query mode, the ATA device
sends the same DNS lookup request to all the DNS
servers at the same time, and the first incoming reply is
accepted by the ATA device.
The default is parallel.
The IP address or name of the primary NTP server.
A
109