Cisco Small Business SPA2102 Administration Manual page 178

ATA Voice Field Reference
Line page
Cisco Small Business ATA Administration Guide
FAX Process NSE
Hook Flash Tx
Method
FAX Disable ECAN
Release Unused
Codec
FAX Enable T38
FAX T38
Redundancy
To use the fax process NSE feature, select yes. Otherwise,
select no.
The default is yes.
Select the method for signaling hook flash events: None,
AVT, or INFO. None does not signal hook flash events. AVT
uses RFC2833 AVT (event = 16). INFO uses SIP INFO with
the single line signal=hf in the message body. The MIME
type for this message body is taken from the Hook Flash
MIME Type setting.
The default is None.
If enabled, this feature automatically disables the echo
canceller when a fax tone is detected. To use this feature,
select yes. Otherwise, select no.
The default is no.
This feature allows the release of codecs not used after
codec negotiation on the first call, so that other codecs
can be used for the second line. To use this feature, select
yes. Otherwise, select no.
The default is yes.
To enable the use of the ITU-T T.38 standard for faxing,
select yes. Otherwise, select no.
T.38 is supported by the SPA2102 and the SPA8000. The
SPA2102 supports a single T.38 connection. The SPA8000
supports one T.38 connection for each of its four modules
(Line 1-2, 3-4, 5-6, and 7-8). The SPA8000 supports a
maximum of four connections, but it does not support two
fax devices connected to the same module.
The default is yes.
Select the appropriate number.
The default is 1.
B
178