PDG-DXL2000 Expand Serial Command Functional Specifications
8.5.4
CF_H – POS Command
Command
"CF_H-POS_%1"[CR]
"0000~nnnn" --- Directly select Horizontal Position setting value
"nnnn" shows maximum value, it is current Total Dots value - Display Dots value
%1
"UP" -------------- Current Horizontal Position setting value + 1
"DN" -------------- Current Horizontal Position setting value - 1
Set Horizontal Position value of PC signal.
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby status or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.5
CF_V – POS Command
Command
"CF_V-POS_%1"[CR]
"0000~nnnn" --- Directly select Vertical Position setting value
"nnnn" shows maximum value, it is current Total Line value - Display Line value
%1
"UP" -------------- Current Vertical Position setting value + 1
"DN" -------------- Current Vertical Position setting value – 1
Set Vertical Position value of PC signal
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby status or ALL is OFF, the value returns to original setting.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.5.6
CF_PCSTORE Command
Command
"CF_PCSTORE_%1"[CR]
"MODE1" ------ Store current PC Adjust status to Mode1
"MODE2" ------ Store current PC Adjust status to Mode2
"MODE3" ------ Store current PC Adjust status to Mode3
"MODE4" ------ Store current PC Adjust status to Mode4
"MODE5" ------ Store current PC Adjust status to Mode5
%1
"MODE6" ------ Store current PC Adjust status to Mode6
"MODE7" ------ Store current PC Adjust status to Mode7
"MODE8" ------ Store current PC Adjust status to Mode8
"MODE9" ------ Store current PC Adjust status to Mode9
"MODE10" ---- Store current PC Adjust status to Mode10
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1~Mode10. This command operates the same as storing to Mode1-Mode10
Details
in PC Adjust MENU.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"101"[CR] ---- When Input source is Video system
"000"[CR]
"Error Code"[CR]
22/72