Cf_Hpos Command; Cf_Ceil Command; Cf_Rear Command - Sanyo PDG-DXL2000 - 2000 Lumens Specifications

PDG-DXL2000 Expand Serial Command Functional Specifications
8.7.8

CF_HPOS Command

Command "CF_HPOS_%1"[CR]
"015" --------- +15
"014" --------- +14
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-14" ---------- -14
"-15" ---------- -15
"UP" ---------- Horizontal Position setting value + 1
"DN" ---------- Horizontal Position setting value - 1
Set Horizontal Position
This command is available in normal Power ON status.
Details Note1) Screen mode is changed into Custom by receiving this command.
Note2) When there is no Input, projector returns 101 and the command does not
execute.
Acceptable
Response
Unacceptable
8.7.9

CF_CEIL Command

Command "CF_CEIL_%1"[CR]
"ON" ------------------------ Set Ceiling to ON
%1
"OFF" ----------------------- Set Ceiling to OFF
Set/Cancel Ceiling setting.
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.10

CF_REAR Command

Command "CF_REAR_%1"[CR]
"ON" --------------------------- Set Rear to ON
%1
"OFF" ------------------------- Set Rear to OFF
Set/Cancel Rear setting.
When Rear is ON, image is left/right reversed.
Details The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
30/72