PDG-DXL2000 Expand Serial Command Functional Specifications
8.4.8
CF_COLTEMP Command
Command
"CF_COLTEMP_%1"[CR]
"000" ------ Xlow
"001" ------ Low
%1
"002" ------ Mid
"003" ------ High
Set Color Temperature. (Available only in the normal Power ON status)
The value set by this command will not be saved to the projector. Therefore, when
Details
turning into Standby status or ALL is OFF, the value returns to original setting.
(The value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.9
CF_PROGV Command
Command
"CF_PROGV_%1"[CR]
"FILM" -------- Select Progressive Mode FILM
"L1" ----------- Select Progressive Mode L1
"L2" ----------- Select Progressive Mode L2
%1
"OFF" --------- Cancel Progressive scan
"UP" ----------- The same operation as pressing Up key or Left key
"DN" -----------The same operation as pressing Down key or Right key
Set / cancel Progressive scan
The value set by this command will not be saved to projector. Therefore, when
Details
turning into Standby status or ALL is OFF, the value returns to original setting.
(The value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.10 CF_NZRED Command
Command
"CF_NZRED_%1"[CR]
"OFF" ------- Cancel Noise Reduction
"L1" --------- Noise Reduction for moving image
%1
"L2" --------- Noise Reduction for still image
"UP" ------------The same operation as pressing Up key or Left key
"DN" -----------The same operation as pressing Down key or Right key
Noise Reduction based on frame correlation
Select L1 or L2 depending on motion detection
L2 is more effective in reducing noise than L1, however, L2 can have a blur in
moving image
Details
The value set by this command will not be saved to projector. Therefore, when
turning into Standby status or ALL is OFF, the value returns to original setting.
(The value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
19/72