Cf_Logo Command; Cf_ Hdmi Setup Command; Cf_Hdmi Sound Command - Sanyo PDG-DXL2000 - 2000 Lumens Specifications

PDG-DXL2000 Expand Serial Command Functional Specifications

8.10.13 CF_LOGO Command

Command "CF_LOGO_%1_%2"[CR]
%1 "0000"-"9999" ----------------- Set LOGO PIN CODE directly
"OFF" ---------------------------- Disable Logo function
"DFLT" --------------------------- Display Default Logo
"USER" -------------------------- Display Captured Logo
%2
"UP" --------------- The same operation as pressing Up key or Left key
"DN" ---------------The same operation as pressing Down key or Right key
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code "102")
Details PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code "101" by receiving USER in %2 when capture has not
operated.
Acceptable
Response
Unacceptable

8.10.14 CF_ HDMI SETUP Command

Command "CF_ HDMI SETUP _%1"[CR]
"NORMAL" -------------------------- Select Normal mode
%1
"ENHANCED" ---------------------- Select Enhanced mode
Select image mode of HDMI setup.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.15 CF_HDMI SOUND Command

Command "CF_HDMI SOUND_%1"[CR]
"HDMI" ----------------------- Select PCM sound (Digital sound)
%1
"EXTERNAL" ------------- Select External sound input
Select sound mode of HDMI setup.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
38/72