SMTP Setup menu
Use the following menu to configure the SMTP server.
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Server Authentication
No authentication required
Sets the parity for serial input and output data frames
Note: None is the factory default setting.
Determines whether the printer uses the DSR Signal. DSR is a handshaking signal
used by most serial cables.
Off is the factory default setting.
The serial port uses DSR to distinguish data sent by the computer from data
created by electrical noise in the serial cable. The electrical noise can cause stray
characters to print. Select On to prevent stray characters from printing.
This menu item appears only if Serial RS-232/RS-422 is set to RS 232.
Specifies SMTP server port information
Note: 25 is the default SMTP gateway port. Range is 1-65536.
Specifies the amount of time in seconds before the server stops trying
to send the e-mail
Note: 30 seconds is the factory default setting.
Specifies a reply address of up to 128 characters in e-mail sent by the
Sets the printer to use SSL for increased security when connecting to the
Disabled is the factory default setting for Use SSL.
When the Negotiate setting is used, your SMTP server determines if
SSL will be used.
Specifies the type of user authentication required
Note: "No authentication required" is the factory default setting.
Understanding printer menus