Sets the amount of time in seconds the printer waits to receive an
end-of-job message before canceling the remainder of the print
90 seconds is the factory default setting.
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Sets the amount of time in seconds the printer waits for additional
data before canceling a print job
40 seconds is the factory default setting.
Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL or
PPDS emulation print jobs.
Lets the printer automatically continue printing from certain
offline situations when not resolved within the specified time
Note: Disabled is the factory default setting.
Specifies whether the printer reprints jammed pages
Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the pages
is needed for other printer tasks.
On sets the printer to always reprint jammed pages.
Off sets the printer to never reprint jammed pages.
Lets the printer successfully print a page that may not have printed
Off is the factory default setting. Off prints a partial page when
there is not enough memory to print the whole page.
On sets the printer to process the whole page so that the
entire page prints.
Understanding printer menus