Konica Minolta bizhub 25 Administrator's Manual page 152

Error code
F-Code Rx error. The box does not
exist in the machine.
F-Code Rx error. The F-Code
reception is prohibited.
F-Code Rx error. Cannot access the
F-Code box
F-Code Rx error. The F-Code box is
full.
R.2.3 Confirm the remote fax.
R.3.1
R.3.3 Reception was stopped.
R.3.4 Cannot receive at minimum speed.
R.3.6 Some pages were not received
correctly.
R.4.4 Memory overflow.
R.4.1 Inbound document cannot be
received.
R.4.2 Confirm the remote fax.
R.5.1
R.5.2
R.8.1 Cannot send a fax in SuperG3
mode.
R.8.10
R.8.11
Internet Fax / Scan to E-Mail Communication Errors
„
Error code
980, 984, Not able to transmit.
985, 986, Please transmit the message
991, 992, again.
996, 999
987, 988, Not able to transmit. Please
990, 997 confirm setting.
989 Not able to transmit. Please
confirm e-mail address.
994 No reply from the email server.
995 Not able to transmit. Mail server
cannot be found.
1002 Not able to transmit. Stopped.
Error message
Error message
Countermeasure
Check the F-Code box settings on the machine.
Contact the other party to inform them of an
F-Code box which can perform reception, and
request them to transmit the document again.
If you know who the sending party is, ask them
to transmit the document again. If this error
continues to occur, contact your local technical
representative.
If you know who the sending party is, request
them to cut the document and transmit it again.
If you know who the sending party is, ask them
to transmit the document again. If this error
continues to occur, contact your local technical
representative.
Countermeasure
Transmit the document again.
In the mail settings, check whether the
SMTP / POP settings are specified correctly.
Check whether the e-mail address specified
for the destination is entered correctly.
Check the network connection.
Check the DNS settings.
The <Stop> key was pressed during
transmission.
Error Messages 4-5
1
2
3
4