Konica Minolta bizhub 25 Administrator's Manual page 117

34
Press [Close].
35
Press [Attribute Setting].
36
Select the attribute to set, and enter the attribute.
37
Press [Close].
38
Press [Enter].
The message "This server has been set as a default server." is displayed when you register the
first server.
Setting the Primary LDAP Server
„
You can set the LDAP server to use for LDAP searching from the registered LDAP
servers.
Make sure to register at least one LDAP server in advance.
1
Press <Setting>.
2
Press [Management].
3
If an administrator password is set, enter the password and press [Enter].
If an administrator password is not set, proceed to step 4.
4
Press [Network Settings].
5
Press [LDAP Server Setting].
2-64 Specifying the Network Settings