Fuser Removal - Lexmark 11A4006 - Optra K 1220 B/W Laser Printer Service Manual

Fuser Removal

1. Remove the right side cover.
2. Open the controller card door assembly and remove the fan
shield plate.
3. Disconnect the process fan from the engine card and pull it
through the toroid.
4. Remove the rear cover.
5. Remove the rear stacker.
6. The power supply board and the fuser could be hot. Be careful
when you remove them in this step. Remove the four screws
from the rear of the machine and slide the fuser and power sup-
ply board assembly out the rear of the printer. Be careful not to
damage the pick motor cable when removing the fuser and
power supply board assembly.
7. Disconnect the two connectors from the power supply board.
8. Turn the fuser assembly bottom side up, and remove the six
screws from the power supply board, lifting the power supply
board from the fuser assembly.
9. Disconnect the remaining connector from the power supply
board, removing the board.
10. Remove the two screws securing the process fan to the bracket
and remove the fan.
Repair Information 4-11