Printer Setup; Setting The Page Count - Lexmark 11A4006 - Optra K 1220 B/W Laser Printer Service Manual

When the value you want is displayed, press Select to save the
value.
5. To exit the Registration menu, press Return.
To verify the margin values are correct you must print the "Quick Test
Page" from the registration screen. Press Go to print the test page.
While printing the Quick Test Page the "Quick Test Printing" mes-
sage displays. Once the Quick Test Page completes printing, the
Registration screen displays again.
The "Quick Test Page" should be printed on letter or A4 paper.

Printer Setup

Setting the Page Count

This lets the servicer change the page count from the diagnostic
menu. This is used whenever the engine board is replaced because
this board contains the printer's NVRAM Memory where the page
count is stored.
To set the Page Count:
1. Select Page Count from the Diagnostic menu.
•
The current page count displays.
•
The leftmost digit flashes, indicating it is the first digit to be
changed.
2. Press either Menu+ or Menu- until the value you want displays.
3. Press Select to move to the next digit, press Menu+ or Menu-
until the value you want displays. Continue with each digit until
you set the page count. You can press Select to skip a digit.
When you press Select after the final digit, the new page count
is stored in NVRAM.
4. Press Select to save the new page count in NVRAM.
5. Press Return to exit the Diagnostic menu.
3-12