Table of Contents
Advertisement
Paper Feed Roller Removal
1. Remove the upper cover and the left and right side covers.
2. Remove three screws, disengage three hooks, and disconnect
the toner sensor connector to remove the upper front cover
assembly.
3. Remove the right and left springs and lift the upper feed roll
from the paper feed frame.
4. Peel off the two guide sheets (Mylar films). Be sure to com-
pletely remove the double-sided adhesive tape.
5. Use a screwdriver to disengage the bearing phase shift levers at
both ends of the lower feed roll, and raise the lever upward to
4-18
Advertisement
Table of Contents
