Table of Contents
Advertisement
User Error Message
34 Short Paper
35 Res Save Off
Deficient Memory
36 Resolution Reduced
37 Insufficient Collation
Memory
38 Memory Full
39 Complex Page
51 Defective Flash
52 Flash Full
2-6
Explanation
The printer determines the paper length is too
short to print the formatted data. This occurs
when the printer does not know the actual paper
size loaded in the tray. For auto-size sensing
trays, this error occurs if the paper stop is in the
incorrect position. Make sure the Paper Size
setting is correct for the size paper that is being
used.
The printer lacks sufficient memory to enable
Resource Save. This message usually indicates
the user has allocated too much for one or more
of the printer's link buffers; however, modification
of other printer settings which affect the amount of
available memory may also create this condition.
Have the user either install additional memory or
set each link buffer back to the Auto value.
The resolution of the page has been reduced
from 600 dpi to 300 dpi to prevent a Memory Full
error. This message can only occur if the
Resolution Reduction setting is turned on.
Note: 1200 dpi pages are not resolution reduced.
If a 1200 dpi job runs out of memory, a Memory
Full error is displayed.
This message is displayed when the printer
memory used to store pages is too full to collate
the print job.
This message is displayed when the printer
memory used to store pages is full.
This message is displayed when the page is too
complex to print.
This message is displayed when the printer
detects a defective flash. This error may occur at
power on, or during flash format and write
operations. Press Go to clear the message. The
flash is marked as bad and normal operation
continues. Flash operations are not allowed until
the problem is resolved.
This message is displayed when there is not
enough free space in the flash memory to hold
the resources that have been requested to be
written to flash.
Advertisement
Table of Contents
